Out Of Stock
Notify me when its in stockThe specially applied hard chrome layer provides even higher wear resistance. Diamond particles with special shapes ensure optimal sharpening of the blade.
Surface is covered with up to 2 million diamond particles through special processes.
Made of steel. It has a smooth and sharp edge.
The handle part has an ergonomic design.
It has a large thumb guard for your safety.
The blade material is hard chrome vanadium steel.
The handle part is 25 cm (10") long excluding the blade.
How to Use:
- Hold the cutting edge of the blade with the masat at 15°-20° angle, and pull without applying pressure from the base to the tip.
Note:
- If the cutting edge thickness, i.e., the mouth of the blade, is too thick, it needs to be thinned to a thickness of 0.4 to 0.6 mm.
- If the blade gets too hot during sharpening, it alters the structure of the steel, reducing corrosion resistance and blade hardness. Therefore, it may cause you to lose the edge-holding ability of your blade.
- The sharpening process should be applied flawlessly from the base to the tip, creating a thin wire edge on the cutting edge.
- Do not remove the thin wire edge created at the cutting edge to finish the sharpening process.
- If the burr on the edge is not carefully removed, it can significantly deteriorate the cutting sharpness and resistance to dulling of your blade.
- The blade surface should have a straight cutting line, and a serrated or partial edge may cause the blade to break.
- Blades should not be exposed to substances that can cause high corrosion, such as saltwater, for extended periods.
